What we supply
Spa duty is different from pool duty. A spa pump usually has to do two jobs: push enough flow for the jets on high speed, and then run quietly and cheaply for long circulation and heating cycles on low speed.
Our two-speed models are chosen with both duty points in mind. Single-speed models are available where the spa uses a separate dedicated circulation pump.
Connections are union type so the pump can be isolated and removed for service without cutting pipework — important in the tight equipment bays typical of hot tub cabinets.
Key features
- One-speed and two-speed configurations
- Union connections for service without cutting pipework
- Sized for jet duty on high speed, circulation duty on low
- Compact footprint for hot tub equipment bays
- Corrosion-resistant wet end
- Air switch and hard-wire control options
- 50 Hz and 60 Hz motor builds
Typical specification range
The figures below describe the range we normally supply in this category. Model-by-model data sheets, curves and drawings are sent with every quotation.
| Parameter | Typical range |
|---|---|
| Rated power | approx. 0.5 – 3.0 HP |
| Configuration | Single-speed or two-speed |
| Voltage | 220–240 V / 1-ph or 110–120 V / 1-ph |
| Frequency | 50 Hz or 60 Hz, specified per order |
| Flow rate | approx. 10 – 30 m³/h on high speed |
| Connections | 1.5″ or 2″ unions |
| Duty | Jet duty on high speed; continuous circulation on low speed |
| Motor protection | Thermal overload protection |
Ranges are indicative of the category we supply and are not a specification for any single model. Confirmed performance curves, dimensions and nameplate data are issued with each quotation.
Where these are used
Hot tubs
Portable and built-in hot tubs running jets plus a heating circulation loop.
Swim spas
Larger units where jet flow and circulation are handled by separate pumps.
Hydrotherapy pools
Small commercial hydrotherapy installations with long daily run hours.
Tell us what you need
Send us your model requirements, target market and volumes. We reply to every technical and commercial enquiry within one business day.